PROFINET Stacks, Tools and Driver Established in 1989 PROFIBUS is one of the most frequently used bus system for Industrial automation. Caused by the idea of a uniform network from the office down to the sensor and the corresponding introduction of Ethernet to the plant floor some adaptions to this technology were necessary.

solutions for industrial communication

1. I'm only using the eSATA/port multiplier function. So yeah, I have two separate drives presented to the computer over the eSATA interface. This connects to a Gigabyte GA-MA785GM-US2H motherboard which lists the following under lspci: '00:11.0 SATA controller: Advanced Micro Devices, Inc. AMD/ATI SB7x0/SB8x0/SB9x0 SATA Controller AHCI mode'.
2. PROFINET Stacks, Tools and Driver Established in 1989 PROFIBUS is one of the most frequently used bus system for Industrial automation. Caused by the idea of a uniform network from the office down to the sensor and the corresponding introduction of Ethernet to the plant floor some adaptions to this technology were necessary.
3. The only program that shows the real SMART data is the JMRaidSetup program (comes on the EX-50 driver disk, works on Linux). According to strace, it sends special commands the the virtualized drive. The RAID mode is disabled with switches on the back of the case. I hope there is a way to configure the JMB393 as a fully-transparent port multiplier.

RENESAS RX231 - CANopen driver and tools now available

Details

CANopen Master/Slave and EtherCAT for SITARA´s AM437 series available

Details

Multi-Protocol-Solution R-IN32M3 PROFINET-CCB/RT1, EthernetIP+DLR, EtherCAT, CANopen

Details

Generic Open Abstraction Layer the new Middleware from PORT

Details

Franke Kaffeemaschinen Port Devices Driver Manual

RENESAS RZT and RZN1 series available with GOAL -one hardware, one middleware - many possibilitiesintelligent communication solutions come from PORT

Details

Infineon AURIX TC23X Familie - CANopen Stack and Design Tool now available

Franke Kaffeemaschinen Port Devices Driver Ed

Details

PROFINET, EtherNet/IP, EtherCAT your RasPI goes to real time communicationquick and easy

Details

Ready to use Multiprotocol solution PROFINET, EtherNetIP, EtherCATCANopen and CC-LinkIE TSN on request

Details

full CANopen support availableMultiline / 11 + 29bit IDsSTM32CubeG4

Details

CANopen Drivers availableMaster / Slave CANopen Library full Design Tool Support

Franke Kaffeemaschinen Port Devices Driver Ed

Details

port´s communication solutions for 'Industrie 4.0'

Franke Kaffeemaschinen Port Devices Driver Bits

Do you need personal advice? No problem!
Call us: +49 345 -777 55 0